Then the installation starts. But still it is not a good solution yet. Units DC supply voltage 5. This warranty does not apply to any Product the exterior of which has been damaged or defected, which has been subjected to misuse, abnormal service or handling, or which has been altered or modified in design, construction or interfacing. Device driver installer b. ACTiSYS reserves the right to make changes without further notice to any products herein to improve reliability, function or design.
|Date Added:||11 September 2010|
|File Size:||50.68 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
If your data size is too big, then you can send them in multiple blocks. Then you will see the installer file: Modification in Configuration Utility.
Else a welcome screen for PL Driver installer will show up. Please direct browse the installation CD to find the path: This completes the driver installation. In such a case the receiver will get junk data.
Insert the CD into your Mac Machine. This warranty does not apply to any appearance items of the Product, any consumable items such as paper, ink ribbon, or batteries supplied with the Product, or to any equipment or any hardware, software, firmware, or peripheral other than the Product.
Actisys IRLN Manuals
And how to solve? Else it will lead you to the same procedure as Method 1. Then a welcome screen for PL Driver installer will show up. You can select a proper model as you are using right now. Instead of running above file, if you insert Installation CD the second time, the CD will autorun again and system will then detect the driver installed already and ask you to confirm ir220kn same removal procedure.
An utility software is provided for Windows to select the models. If exists, please remove it first.
ACT-IR220LN-9.6 – RawIR (IrPHY only) Serial Infrared Adapter
Acrisys recommend Method 1 in Chapter 12 to un-install the driver. Supports 8 baud rates: Ruggedized version is also available. The latency of a real COM port is about 0. How to improve the channel utilization or throughput? So, if the sending side has completed its sending but some data in dongle buffer still pending transmission before you close the COM port, DTR and RTS signal will get change consequently.
To prevent this, we recommend giving some delay time before closing the port, which ensures all pending data being sent out completely. Do I need to restart the PC? Device driver installer b. Normally this Raw IR transmitting dongle has no flow control ir220nl. Units DC supply voltage 5. Please refer to item 4. Click Finish button to complete the Un-installation as below.
Otherwise explore the CD contents 4. Added Factory Default Setting section. This should remove the driver from your Mac machine. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Such application needs to be updated.
We highly recommend restarting the PC so that you can complete the un-installation successfully.